This is a discussion on felicia over revving within the Favorit, Felicia, Fun and Forman forums, part of the Skoda Model Discussion Area category; help needed the wifes car would start on saturday but would not tick over so i cleaned the throttle body ...
| |||||||
Pronounced "bris-skoda", a brisk skoda. | Register | FAQ | Members List | Calendar | Mark Forums Read |
| | #1 |
| Briskodian Join Date: Feb 2007
Posts: 24
| help needed the wifes car would start on saturday but would not tick over so i cleaned the throttle body . drove the car everything fine sunday morning car would not tick over , so i changed the crank case sensor because i was given 1 with the car. the car then drove fine this morning the wife tells me the car is over revving and slowley going back to normal any ideas folks the car has a 1.3 mpi engine sean |
| | |
| | #2 |
| Briskogre Join Date: May 2006 Location: Hayling Island, Hampshire
Posts: 7,162
| sounds like you have an air leak somewhere... what did you take off when you cleaned the throttle body?? |
| | |
| | #3 |
| Briskodian Join Date: May 2007 Location: Northern Ireland
Posts: 92
| Did you completely remove the throttle body to clean it? If so i think you'll need to replace the inlet manifold gasket |
| | |
| | #4 |
| Briskodian Join Date: Feb 2007
Posts: 24
| all i done was jus sprayed the carb cleacer in to the throttle body sean |
| | |
| | #5 |
| Briskodian Join Date: Mar 2008 Location: Santo Domingo
Posts: 5
| this is my though, the engine's carb was tune to the not so nice carb, wen you sprayed the cleaner then the tuning had to be fixed, i would tighnt the idle screw all the way down (engine suppozed to stop at this point) then correct the accelerator screw, until engine stops and give it 1 turn more, then release the idle screw and adjust it until propper idle (i have mine from 850-900rpm) |
| | |
| | #6 |
| Briskodian Join Date: Oct 2006 Location: Newcastle upon tyne
Posts: 358
| My advice before taking anything apart would be to disconnect the battery for two minutes to clear the ECU and try again before ripping anything apart. If this does nothing then i would suspect the Inlet Manifold gasket as previously stated. However, it may be the case that it is just the throttle body gasket that has been disturbed by carb spray. Either way it will not cost more than a few pounds and a couple of hours at the most.
__________________ Skoda 1.3GLi 1998 now reading LXi on the back due to tailgate swop. Bought for £30 and still going strong |
| | |
| | #7 |
| Briskodian Join Date: Feb 2007
Posts: 24
| i have disconected the battery and the ecu . the car went fine last night but the wife says its like a kangaroo this morning . i noticed when i left the car idling the revs waiverd sean |
| | |