Star performance re-map instructions

[turboman6680]

Hi Jim,

Got my silver Fabia VRS re-mapped around this time last year from you guys.

Two questions for you -

1) is it possible that you could post instructions on how to put car back to standard power and vice versa using the 'pocket power' module please? I hate having to hassle you all the time but because i dont do it all the time, i forget how it goes!

Any chance?

2) also, having had other mods done to the car now including de-cat pipe, pd160 kit and cotton filter and soon a possible milltek exhaust - will my car be possible of producing more power through getting it re-mapped by yourselves again now these are all done. When it was done this time last year, it was 100% standard.

Thanks very much

Dave

[faboka vrs]

You can download the instructions from here

http://www.milfordmicros.co.uk/milfo...100/Manual.pdf

[Bigw2069]

Instructions for DPT when using the FIRST time.

Plug in the unit to port and turn on ignition
The amber light will come on, now push and hold till the light flashes , then release the button.
The amber light will flash, leave it until it stops flashing, about 3 mins, when the green light is constant it means it has coded itself to the ECU box and stored the standard map.

Instructions for switching between maps

A light tap on the button will allow you to switch between software, (Green light = Standard software, Red light = Modified) If you select the red light just hold the button in for a moment until it starts to flash, release the button and wait a few minutes for flashing to stop and Green & Red lights to stay on constantly, Turn ignition off and remove unit.

To reload standard software, plug unit back into Diag port and turn ignition on, select green light and press and hold till green light flashes, wait 3 mins for constant green light, turn off ignition and remove unit.

WARNING: DO NOT REMOVE UNIT WHILE LIGHT IS FLASHING

Hope that helps.

[starperformance]

Great to see people helping out.
Thanks Jim.